Facts and Figures

For this project, it was necessary to construct a timeline and budget. The timeline created, which is pictured below in Table 1, is set up as a guide for the group to follow while the project is being constructed. It is ideal for the group to complete each task within the time frame set forth; however, the deliverables for each can be altered if a complication arrises. In addition to the timeline, the budget is also pictured below in Table 2.  It can be seen that the total cost to create this project is relatively low; the reason for this is that the Innovation Studio and some of the engineering labs were able to supply the group with the majority of the supplies needed.

Comments

Post a Comment

Popular posts from this blog

Week 9

Image
Week 9 Goals: Analyze test data, work on final report and final presentation This week the group had two main goals. The first of these was to analyze the data collected from the stationary and mobile tests that were performed. Tables 1 and 2 display the data gathered for the stationary and moving tests respectively. It is quite clear that the moving solar cells were much more effective than those that were stationary. While the voltage decreased with each measurement for that stationary panel, that of the mobile cells stayed relatively consistent. This shows that the moving solar cells gather more energy throughout a certain time period. Table 1: Results from Stationary Test Table 2: Results from Mobile Test The second goal was to begin working on the final report and presentation. For the final report not much is left to be done. In the previous week, the group completed a final draft which was then submitted and commented on by the section instructor and TA. E...
Read more

Week 3

Image
Goal: Order Majority of Materials and Write Skeleton of Code One of the main goals for this week was to order the majority of the materials needed to create this product. The two things that purchased were the Solar Panel Cell Kit as well as the LED light strips. It is estimated that these items should arrive within the next week.  Once the group gains possession of the items ordered, the building process will be able to begin.  The second main goal for this week was to gain a better understanding of the Arduino Software and create a base code to operate the system. The Arduino chip is a necessity for this project because it is an intermediate step between the motor and the window. Without it, there would be no way for the the two objects to communicate to one another, resulting in an unusable system. Figure 1, which is pictured below, displays an image of the Arduino itself along with the other parts included in the kit. Figure 1: Image of a Basic Arduino Chip ...
Read more

Week 6

Image
Goal: Start Construction of Solar Cells, Continue Debugging Code, and Write Final Draft This week, the group set out to achieve multiple goals, beginning with the construction of the solar cells. Rather than order individual solar cells, the group chose to opt for a complete solar cell kit. The kit included fifteen six inch by six inch solar cells, a flux pen, a soldering iron,  and tabbing wire. All of these items are pictured below in Figure 1. Assembling the solar cells proved to be more of a challenge than initially anticipated. The instructions included in the kit were very vague and, due to the group’s lack of solar cell knowledge, were very confusing. To insure we assembled them in the proper manner, we reached out to Mohammad Nozari, a TA here at Drexel to answer a few of our questions and help guide us through the process. He is currently doing research regarding solar cells and kindly agreed to meet with us during the upcoming week. Figure 1: Solar Cell Kit Compo...
Read more